Testsystems

Motor types

One test bench for 4 motor types

Koob test benches measure the magnetic field of permanent-magnet and externally excited rotors, radial and axial, and the magnet tracks of linear motors. With our universal test bench, a few changeover steps switch the measuring setup to another motor type in minutes, so one bench can test 4 different motor types.

  • PSM
    PSM

    Permanent-magnet synchronous motors

    Permanent-magnet radial rotors, surface-mounted or embedded

    • Single sensor approx. 30 s – 5 min
    • Sensor array 8⁠–⁠15 s
  • EESM
    EESM

    Externally excited synchronous motors

    Externally excited radial rotors, energized through a slip ring

    • Single sensor approx. 30 s – 5 min
    • Sensor array 8⁠–⁠15 s
  • AFM
    AFM

    Axial flux motors

    Disc rotors, measured across the face of the disc

    • Single sensor approx. 30 s – 5 min
    • Sensor array 8⁠–⁠15 s
  • LINEAR-MOTORS
    Linear motors

    Magnet tracks and secondary parts, scanned along their length

    • Sensor array 8⁠–⁠15 s

Evaluated against your criteria

Whatever the motor type, the software evaluates every pole by the same main criteria and decides pass or fail against your targets. Test plans store the measurement and test settings, so you can switch between motor types whenever you need to. Depending on the motor type, the software offers additional test criteria and views.

  • Peak, polarity, width and center of every pole
  • Pole symmetry and FFT field analysis

Three ways to set the targets

  1. Pole against pole Each pole against the mean of all poles
  2. Target values From your drawing, specification or simulation
  3. Reference rotor A reference part as the comparison for all others

How pass/fail is decided

Overview of all fault patterns

Peak · Polarity · Width · Center

Compare motor types

PSMEESMAFMLinear motors
Measured from CircumferenceCircumference, under excitationFace of the discAlong the track
Motion RotationRotationRotationLinear travel
Max. rotor diameter 250 mm250 mm——
Max. part length 500 mm500 mmOn request400 mm
Single sensor approx. 30 s – 5 minapprox. 30 s – 5 minapprox. 30 s – 5 min—
Sensor array 8⁠–⁠15 s8⁠–⁠15 s8⁠–⁠15 s8⁠–⁠15 s
Special hardware —Slip ring contacting and programmable excitation——

Contract measurement

Test it on your own rotor first

Send us one of your rotors, or we come to your plant in Germany with a mobile test bench. You receive the 3D model of the field, the pole analysis and the measurement data – before you decide on a test bench of your own.